Les annonces; à vendre toutes voitures pre-war

Large chromed headlight off a circa 1932-1934 American or English car. Outer diameter 24cms. Good chrome, excellent reflector and glass. Width of rum 5 ½ cms. Length of light 20cms. Only one small ding in back of housing, barely noticeable. Do not have a pair.

Vacuum-tank as used in a number of US made cars in the 1920's. In restorable condition, complete with filter on top.

Orphan cowl light, make unknown, for on Edwardian or early vintage English car. Needs to be re-nickeled. Small dent on rear of body. Outer diameter 13 ½ cms. Good reflector and glass. Bulb by Lectra.

Carter Type W1 downdraught carburetor. 35mm throat. In serviceable condition.

Pair of cow lights complete with mounting brackets for American cars of the late Twenties early Thirties, e.g. Chrysler, Dodge DA, and Victory Six etc. In good condition, only one of the rims has some dents which need attention. 11cms diameter. Length of brackets 16cm.

Older American updraught carburettor made by Kingston. Model L1, N° T 61361. Large 40mm throat. E.g. used on tractors and trucks. Good overall condition for age but cork float needs to be remade.

Sankey type spoke wheel for a vintage car in good condition. 12 spokes, 20 inch and 6 studs. 124mm diameter centre hole and 161mm measured across the stud-holes.

Nos carburettor for Ford V8 flathead. Also used on Judson compressor.

Wire spoked wheel for pre-1925 American cars. 6 stud, for beaded edge tyres, 85mm width, overall diameter 644mm. Stud spacing 160mm. Three spokes need to be replaced. This pattern was made by several American manufactures including Hayes, Dayton and Houk for car such as Hupmobile, Buick and Marmon.

One downdraft Tillotson carburettor with 27mm throat. Distance between bolt centres is 60mm.