Large veteran American acethylene-gas headlight complete with its mounting bracket. Make of light or off which car or truck it came is unknown. Light is in very good condition for its age but rear reflector and glass are missing. Overall diameter 22cms. Distance between forks 20cms. Length of housing 16cms. Height of bracket approx. 40cms.
Steering wheel, column and box suitable for a prewar sports- or racing car or special. Origin unknown. Short column only 520mm. Diameter wheel 380mm. Good condition.
North East 12 Volt "ooogahh" horn. Fully restored condition, ready to bolt on your car. Suitable for e.g. 1925-1930 Chrysler, De Soto and Plymouth etc.
Large Claxon type horn made by the American Bosch Magneto Corporation of Springfield (Mass.) USA - in good condition. Chrome will polish up. 14cms outer diameter.
Large American electrical headlight (one only) with original fork for veteran car of around 1910-1915. Made by the Vesta Accumulator C° - Chicago. Model N° 1125. Only one small dent in housing, easy to take out. Good reflector but glass is cracked and needs replacing. Outer diameter between hinges 30cms. Would benefit from a fresh coat of paint...
Sankey type spoke wheel for a vintage car in good condition. 12 spokes, 20 inch and 6 studs. 124mm diameter centre hole and 161mm measured across the stud-holes.
Wire spoked wheel for pre-1925 American cars. 6 stud, for beaded edge tyres, 85mm width, overall diameter 644mm. Stud spacing 160mm. Three spokes need to be replaced. This pattern was made by several American manufactures including Hayes, Dayton and Houk for car such as Hupmobile, Buick and Marmon.
Three 17 inch wire spoked wheels believed to have come off a 1930's English car (Ford or Vauxhall). Center hole diameter 98mm. Distance between stud holes 132mm. Will take between 4.50 and 5.00 x 17 tyres.