Les annonces; à vendre toutes voitures pre-war

2 model A Ford – Sparton 6 volt 1 Klaxonet 12 volt1 Handklaxon.All worksEur 150 each + shipping

For sale: Rear Ford Nordlipp hood ornament for 1935/1936 Ford, oval type, in good overall condition.The red glass insert is missing, and there is a small chip at the rear (see photographs). The ornament is currently mounted on a non-Ford trim piece, likely not original.Worldwide shipping is available at buyer’s cost.For furt..

Pair of repro stepplates for Model A Ford complete with screws and rings .In our Dutch warehouse.€ 200

Scintilla 12V 60W regulatorsuits Bugatti T57

Made by Brasswork in USA , around 10 years ago.A brand new in Europa is eur 3.200Mine is eur 1.800 + shipping.

The engines are completely rebuilt and upgraded including, lightened flywheel,. Shells in the big ends and main bearings, replacing the white metal bearing system, 6:1 high compression cylinder heads, bored out to 0.125” to 3.45 litres and fully balanced, new pistons and connecting rods, new valves, guides and springs, rebuilt oil pump.  ..

Very rare radiator for a French Ford Model T  1917-1924. This radiator was supplied as a accessoire by Chausson and should fit a Model T without any alterations. This type of radiator was to "modernise" the car with a Coupe-Vent radiator. The radiator has been recored with the correct type of core and the radiator shell has been restored and nickel..

One end 1920s Ford Model A engine in overhauled condition , still needs fresh sparkplugs and distributor cap. plus carburetor. Is in our Dutch warehouse. € 4500

A Pair of NOS (New Old Stock) Stub Axles with NOS Shackle Pins, New Ball Studs for Cross Arm, and New Grade 8 Castle Nutsfor 1932, 1933, 1934 Ford Passenger Car and Light Commercial Vehicle (Pickup).Regular Left Hand Drive.   

Dynamo/générateur Rotax. Convient aux voitures britanniques de qualité, anciennes ou de collection. Complet et en bon état d'origine. Non testé. Voir les photos pour la description de l'état et des dimensions. 12V 10Amp, estampillé  « 3874 ». Entraxe des trous de montage 4 1/2« , diamètre de dégagement 1/4 ». Peut-être retiré d'un ancien Sunbeam..