Les annonces; à vendre toutes voitures pre-war

J2/MMM  Rocker cover support brackets(2)-Euro20J2/MMM Rocker shaft central support brackets(2)-Euro20J2/MMM original pencil type rear/number plate light, screw fixing with bayonet connection-needs clear cover to illuminate number plate.-Euro5J2/MMM Rear HTS axle `U` bolts(4)- Euro 28Lucas King of the Road chrome flang..

An original Bonora quick release radiator cap in very good condition retaining most of original chrome plating.  Internal thread is about 1.93 inch diameter.  This is an original cap of the 1930s not a reproduction.  Buyer pays shipping cost.

MG rocker cover and cap. Looks like it has been extended. Length is 18 3/8".

VINTAGE AUSTIN    7 PROP SHAFT   HARDY SPICER TYPE  1934-39?LENTH 2ft x2.1/2inch  LONGGOOD SOUND CONDITION

1) Rotax DJ4-3 manual advance/retard distributor from early J2(? fit D or M types) in working order complete with drive dog,points, condenser,  screw down greaser and cable acorns.One cap clamp has top missing but still clamps(S & V have these)- Euro100 2) Steering column mounted actuating rod and lever for above, complete with upper..

Original bracket for 3 terminal Lucas junction box (with clip on lid) for MG MMM and similar cars of late 1920's and 1930's.  This is an original part; overall length 3"; width 0.75"; two holes for junction box at one end and one 5/16" diameter home at the other.I have PayPal and will post world wide

1 complete set Crown Wheel and Pinion for FIAT 52B ratio 59 teeth crown wheel & 12 teeth pinion

These SU H3 carburettors are in good condition and, whilst they would need rebuilding (which I can do for you), all of the service parts are easily available. The throttle shafts are not anywhere near as worn as some I have worked on but for perfection they could have new bushings fitted. I know what the modern replacement parts for these carburett..

An original 12 volt Lucas Altette horn.  It is complete and in very good condition and full working order.  All original correct dome nuts are present etc.  Buyer pays shipping cost.

Advance and retard control rod.  Bolts to steering column.  In two sections , top section (what you see  mounted to steering Column) is as per pre war MG (and Morris), lower section could be Wolseley Hornet. You will need threaded sleeve making if you are to use both sections and join together.  Study photo's, what you see if what you get..