Les annonces; à vendre toutes voitures pre-war

Aperçu d’annonces associées à cette annonce MG badges for MG

  • Thermometer MG

    Thermometer MG

    Thermometer MG 10 x 5 cm
  • CARBODIES body badge

    CARBODIES body badge

    In aluminium, and in high relief, an unstamped original badge ready to fit on any body as made by Carbodies of England, or any body that is an accurate replica of a Carbodies body. Rolls Royce, Bentley, Invicta had bodies made by this firm.Postage at cost.
  • CORSICA body badge

    CORSICA body badge

    Original and as new, the badge is chromed, and the red painted part is slightly indented. A beutiful piece, suitable for all bodies as made by Corsica after 1927. In 1928 chromium plating was used extensively as the new untarnishable finish.Will post at cost.
  • MG F type ENV gearbox , gear-set

    MG F type ENV gearbox , gear-set

    Set of ENV F type gearbox gears , they are in excellent condition with very little wear , and no chips etc , the corroded spacers on the cluster assembly are from another water damaged gearbox and not indicative of these gears . I have listed at a relatively low price as the gears are quite heavy and postage will reflect that .
  • Bodywork badge Body By Fisher

    Bodywork badge Body By Fisher

    Bodywork badge Body By Fisher
  • Bodyplate Society Belge Des Automobiles Citroen

    Bodyplate Society Belge Des Automobiles Citroen

    Bodyplate Society Belge Des Automobiles Citroen
  • Automobile Peugeot Paris reproduction

    Automobile Peugeot Paris reproduction

    Automobile Peugeot Paris reproduction
  • Body plate badge Amilcar St. Denis

    Body plate badge Amilcar St. Denis

    Body plate badge Amilcar St. Denis
  • Wire Wheels and Blockley Tyres

    Wire Wheels and Blockley Tyres

    For MG prewar or other sport cars:4.00 x 19 Blockley and wheels Tyres,  2.5 x 19 48 Spoke Good condition 4 grey and 1 paint blue (rear)Pick up in Brussels Belgium or good solution post
  • MG P type aluminium block .

    MG P type aluminium block .

    from a deceased estate , new un-machined aluminum P type block . I have roughly measured the barrels , it will easily take liners for 60mm bores and possibly as much as 62 depending in the required wall thickness of the liners . It weighs 17kgs so postage at cost but should not be ridiculous .

En promo